50m-roll Warm White Top Bend Neon Flex | 15x15mm | 3000K

50 metres roll Top Bend High Bright Warm White Silicone LED neon flex 3000K CRI>90 - 24V IP65/67- 15x15mm

Silicone LED Neon flex powered by 3000K very warm white CRI>90 SMD2835 LED chips

15mm wide x 15mm height

Flame Retardant - UV Resistant - Salt water resistant - Solvent resistant

Suitable for installations on yachts, facade lighting, indoor and outdoor projects.

Flat design for architectural lighting (Top Bending). Sits flush along edges and provides a 160 degree beam angle.

Up to 45 degree internal bend

15 W/m – 24V DC – 120 LEDs/m – IP65/67 – 2 wire - Silicone

CCT 3000K, light output >700 lm/m

LED Neon flex can be cut at every 5 cm (50mm)

You will receive a continuous run of 50 metres (one roll). Please do not test the entire length - you will risk burning out the pcb / chips.

Returns are not accepted unless it's a complete 50m Roll.

Also, if connectors and end caps are required, these need to be purchased separately (see associated products below). You will only receive tail ends when you purchase a 50m roll. Connection Kits for 15x15mm Flex require soldering.

3 year warranty

IP67 rating is subject to correct installation

The high quality of Hi-Line LED Neon flex products ensures low decay, which increases the LED's lifespan and assures that the level of the brightness is kept constant throughout the LED's estimated life.

Please do NOT connect more than 10 meters of LED flex in series. A LED flex of more than 10 meters in length will overloaded, due to the increased amount of current passing through, resulting in the damage of the internal FCB and failure of the product. A maximum of 20m of this product can be installed in a single run only with 24V power fed from both sides in parallel. Alternatively you may power the flex (24V DC) in the middle of the run (leaving 10 meters LED flex to the left and 10 meters to the right).

All Hi-Line LED neon flex are PWM dimmable. Please select a suitable PWM LED dimmer/controller to ensure the proper dimming of the product.

LED neon flex is fully compatible with Lutron, Fibaro, Rako or ANY conventional constant voltage LED controller available on the market. We do also offer a wide range of single colour LED controllers including wireless, DMX512, ZigBee, DALI and and 0/1-10V to choose from.

Selection of the LED driver (LED switch mode power supply) depending on the maximum LED Neon Flex length

To consider best power supply performance, we suggest using 20% higher capacity (Wattage) of what the rated power consumption of neon flex will be.

Note: for driving single colour LED neon flex, you just need the flex, power connector and LED driver. If dimming is required you will have to combine the LED-Driver with a single colour LED dimming controller. In such a case, the LED driver is not required to be dimmable. Brightness control (dimming) and colour adjustment is still possible through the controller.

Looking for Related Products or Accessories?

Click the 'Related Products' tab below the product description to find compatible LED strips, drivers, and accessories. For technical data or installation guides, check out the 'Attachment' tab for available PDFs. To refine your search further, use our "REFINE BY" filter system available when browsing any product category.