Premium series 30W 24V LED driver - 5 years Warranty
This is a highly specified switch mode-constant voltage power supply using the best electronic components in the market.
Non-dimmable LED Driver suitable for LED Strips of total power consumption up to 30W.
It is recommended to calculate 20% more than the tape power consumption for better performance of the power supply.
As an example this LED Driver can be used for up to 1.7 meters of high power single colour or RGBW LED strip (14.4W per meter X 1.20 load factor). Of course same applies to single colours LED strips that consume 14.4W per meter.
LED Driver 30W/24V
Input: 85~265V AC (50/60Hz)
Output: 24V / 1.25 Amps
Suitable for LED Strips
Rating: IP67 (Waterproof)
Power factor: >0.98
Efficiency: > 85%
Ripple: <2%
Dimensions: L152*W45*H33 mm
Weight: 316g
Warranty offered for the LED driver is 5 years
Note that LED strips dimming is possible if this driver is used in combination with an LED controller. In such case LED driver is not required to be dimmable and brightness control (dimming) is still possible through the LED controller.
For driving RGB or RGBW LED Strips, you will have to combine the Driver with an RGB-RGBW LED Controller.
IMPORTANT NOTICE!
This device should be installed by a qualified electrician in accordance with the latest edition of the IEE Wiring Regulations and any applicable Building Regulations.
The table below shows the maximum LED strip length, which can be operated with this LED driver.
To consider best power supply performance 20% was deducted from the maximum strip length in the table below.
For more information about the installation of LED Strips, you can download PDF file from the attachments tab: “Installation of LED Strips”.
