Fanless constant voltage 200W 12V LED driver IP20 - 3 years Warranty
Non-Dimmable LED Driver suitable for LED Strips of total power consumption up to 200W.
It is recommended to calculate 20% more than the tape power consumption to cover losses of the circuit and efficiency of the power supply.
Note: This is an economy series driver. If you prefer lower in-rush current and higher power factor products, then consider our premium series drivers instead. Installers should be aware of in-rush current and the type of MCB required in such cases.
To learn more about In-rush current, visit out support page HERE
LED Driver 200W/24V Suitable for LED Strips
Input: 175~264V AC (50 Hz)
Output: 12V / 16.66 Amps
Rating: IP20 (Non-Waterproof)
Dimensions: 195*48*30 mm
Weight: 300g
The warranty offered for the LED driver is 3 years
Note that LED strips dimming is possible if this driver is used in combination with an LED controller. In such case LED driver is not required to be dimmable and brightness control (dimming) is still possible through the LED controller.
IMPORTANT NOTICE!
This device should be installed by a qualified electrician in accordance with the latest edition of the IEE Wiring Regulations and any applicable Building Regulations.
The table below shows the maximum LED strip length, which can be operated with this LED driver.
To consider the performance drop, which occurs in the power supply cable, and the efficiency of the LED Driver, 20% was deducted from the maximum strip length in the table below.
For more information about the installation of LED Strips, you can download the above PDF file: “Installation of LED Strips”.
