High CRI Ra >90 LED Strip Light, 14.4W/60LEDs per meter Extra Warm White (5 meters roll)
24V Commercial high grade LED Strip / Tape powered by SMD2835 LED chip CCT: Extra Warm White 2200-2400K
The width of this LED strip is 8mm, height 3mm and can be cut at every 6 LEDs (10cm)
Non-Waterproof IP00, 24 Volts constant voltage extra warm white Ultra High Bright LED Strip SMD2835 Chip, 60 LEDs 14.4W per meter, 5 meters roll with 3 years Warranty.
This is a high brightness LED strip, powered by Epistar SMD2835 LED chips (1320~1440lm per meter/14.2W/60 LEDs)
All our LED Strips are dimmable. Please select a suitable PWM LED dimmer/controller.
*5-year warranty:
*This LED tape should be installed according to our installation instructions. For more information on installing, please see the installation manual in the attachments tab and to learn more about the 5-year warranty on offer, please refer to the following link:
LED Strip Warranty Guide
Please note that soldering is recommended for the connection of LED strips. However, if a solder free connection is preferred, Hi-Line’s solder free connectors offer the best solution currently available on the market.
Price is for a 5 meters roll (300 LEDs), non waterproof (IP00), 14.4W/m CRI Ra>90 LED strip extra warm white 2200 to 2400K
Selection of the LED driver depending on the maximum LED strip length
The table below shows the maximum LED strip length, which can be operated with a given LED driver.
To consider the performance drop, which occurs in the power supply cable and the efficiency of the LED Driver, 20% was deducted from the maximum strip length in the table below.
Note that LED strips dimming is possible if the driver is used in combination with an LED controller. In such case LED driver is not required to be dimmable and brightness control (dimming) is still possible through the LED controller.
For more information about the installation of LED Strips, you can view the PDF file in the attachments tab, called Installation of LED Strips
