Warm White LED Strip 5m roll | IP65 | 3000K | 24V | 7.2W/m | CRI90

IP65 High CRI Ra >90 LED Strip Light - 60 LEDs/m - warm white - 7.2 Watt per meter - 5 meters roll

Waterproof IP54/65, 24 Volts constant voltage - warm white 3000K

High Bright LED Strip SMD2835 Chip, 60 LEDs/m, 7.2W per meter, 5 meters roll.

This is a high bright LED strip, powered by Epistar SMD2835 LED chips (660 lm per meter/7.2W/60 LEDs)

The width of this LED strip is 8.5mm, height 3mm and can be cut at every 6 LEDs (10cm)

3 Years Warranty

All our LED Strips are dimmable. Please select a suitable PWM LED dimmer/controller.

Please note that soldering is recommended for the connection of LED strips. However, if a solder free connection is preferred, Hi-Line’s solder free connectors offer the best solution currently available on the market.

Note: IP00 8mm connectors are required for this strip. The fitting with these connectors may feel tight, but if you line up the contacts before closing the connectors, it should clamp down comfortably (please see additional photos). 

Price is for a 5 meters roll (300 LEDs), waterproof (IP65), 7.2W/m CRI Ra>90 LED strip warm white 3000K

Selection of the LED driver depending on the maximum LED strip length

The table below shows the maximum LED strip length, which can be operated with a given LED driver.

To consider the performance drop, which occurs in the power supply cable and the efficiency of the LED Driver, 20% was deducted from the maximum strip length in the table below.

Note that LED strips dimming is possible if the driver is used in combination with an LED controller. In such case LED driver is not required to be dimmable and brightness control (dimming) is still possible through the LED controller.

For more information about the installation of LED Strips, you can download “Installation of LED Strips”.