Commercial high grade LED Strip / Tape
5 METER WATERPROOF IP65 SMD 3528 LED STRIP LIGHT WITH 600 LEDS IN RED
Can be cut at every 6 LEDs (5cm), Width of the LED strip is 10mm.
24 Volts DC, Splashproof (IP65) LED strip powered by SMD3528 LED chip, 120LEDs/m, 9.6W/m, 5 meter roll, colour: red
The quality of this product is superior!
Due to the very thin coating on NPU strips, it is not possible to use IP65 connectors. This is because of the connector’s concave design, which won’t clamp onto the strip when closed. As such, it is recommended to use the equivalent IP00 connectors, such as the IP00 10mm Strip-to-Wire Connectors and the IP00 10mm Strip-to-Strip Connectors.
All our LED strips are dimmable. Please select a suitable PWM LED dimmer/controller. The LED strip cannot be dimmed in any other way!
Fitted with an easy to install original 3M adhesive tape with excellent adhesion (identified by a red protective strip on the adhesive side).
Please note that soldering is recommended for the connection of LED strips. However, if a solder free connection is preferred, Hi-Line’s solder free connectors offer the best solution currently available on the market.
Our price is for 1 x 5 meters roll (600 LEDS) single colour LED Strip (Red) - IP65 Splashproof
Selection of the LED driver depending on the maximum LED strip length
The table below shows the maximum LED strip length, which can be operated with a given LED driver.
To consider performance drop, which occurs in the power supply cable, and to consider the efficiency of the LED Driver, 20% is deducted from the maximum strip length in the table below.
Note that LED strip dimming is possible if the driver is used in combination with an LED controller. In such a case, the LED driver is not required to be dimmable and brightness control (dimming) is still possible through the LED controller.
For more information about the installation of LED Strips, you can download the above PDF file: “Installation of LED Strips”.
